[Yun]

Ello!! ~♥~

Well, Mayonaka sent me here to state my problem, so here we go.... >.<

Well, I got Reika (my pullip....) an SBH obitsu body.. Everything was fine after installation for about a week. Now, the lower torso keeps popping off no matter what I do!!! The joint is still attached to the upper torso when this happens, but I can easily remove it.. I can put it back together, but it takes me a LOT of time, and she just pops open again a few minutes later!!!

... Any ideas on what I should do??

I had this problem with a few of my girls SBH bodies too. What I do is, before I put the pieces back together (the torso pieces) I put a small bit of glue on the tip of the peg, then carefull slot it back into the hole. I usually use white glue (a liquid glue that will dry clear) not super glue, because super glue dries fast, so if I should miss the hole, it'd stick in the wrong place.
You'd probably have to hold her 'till the glue dries. The glue I use takes approx. 15 minutes to dry, it's your average crafting glue to stick together paper, cartboard, wood, plastic... etc. No specific brand. But it works for me

[Harmony909]

Ello!! ~♥~

Well, Mayonaka sent me here to state my problem, so here we go.... >.<

Well, I got Reika (my pullip....) an SBH obitsu body.. Everything was fine after installation for about a week. Now, the lower torso keeps popping off no matter what I do!!! The joint is still attached to the upper torso when this happens, but I can easily remove it.. I can put it back together, but it takes me a LOT of time, and she just pops open again a few minutes later!!!

... Any ideas on what I should do??

I had this problem with a few of my girls SBH bodies too. What I do is, before I put the pieces back together (the torso pieces) I put a small bit of glue on the tip of the peg, then carefull slot it back into the hole. I usually use white glue (a liquid glue that will dry clear) not super glue, because super glue dries fast, so if I should miss the hole, it'd stick in the wrong place.
You'd probably have to hold her 'till the glue dries. The glue I use takes approx. 15 minutes to dry, it's your average crafting glue to stick together paper, cartboard, wood, plastic... etc. No specific brand. But it works for me

Oh, thank you so much!!!! I'll have to try that... I have some glue right now, so I'll try that in a minute!

Thanks again!!!

[Yun]

Oh, thank you so much!!!! I'll have to try that... I have some glue right now, so I'll try that in a minute!

Thanks again!!!

No problem! Hope it works.

[Kitty Desu]

  thanks so much!

great idea and super easy.